Monday, September 5, 2011
WHAO!
Long time no post! I have recently been printing exclusively in Natureworks LLCs Ingeo 4043D, I have recently found a supplier for Ingeo 4042D. Now, I have heard that people used to have problems with PLA, but I think that this was 4032D. If I can get good results with this plastic, I fully intend to resell it. Anyone up for some samples? :D
Tuesday, February 1, 2011
The Experiment: Part 1 Day 2
Well, For what it's worth, I'm all about some bubble lovin'...but this little guy is just covered with them. Is this because of air seeping out of the infill, water replacing air in the plastic itself, the plastic sucking oxygen out of the water, or some conglomeration of all three? Who knows!
Subscribe to:
Posts (Atom)